¥14300
1-4台
¥14200
5-9台
¥14100
≥10台
起订量
≥1台
总供应
200台
所在地
江苏省苏州市
J2110A Solid State Voltage Injector
1、 DC~45MHz的频宽可支援温度及机械控制(loop band width< 1Hz)和Z高性能调节器及放大器量测
2、 优异精确的低失真表现
3、 25Ω串接插入电阻
4、 50Ω 输入阻抗(OSC port)
5、 < 3uA偏压电流
6、 > 2 MΩ输入电阻(IN port)
7、 可配合通用输入型的高PSRR 低噪音稳压器(J2170A)使用
8、 详细规格
產品说明
While it is possible to obtain high quality injection transformers with bandwidths as wide as 1Hz to 5MHz or more, in some cases this is still insufficient for some tests. For example a typical heater control loop might have a bandwidth of less than 1Hz while some linear regulators and opamp circuits can have bandwidths of up to 100MHz or in some cases even higher. For these applications, a solid state injector can provide the necessary bandwidth. A solid state injector can perform at DC, while the upper frequency limit is dictated by the components selected and the printed circuit board material and layout. It is possible to obtain a solid state injector with a working range of DC – 200MHz, though above 50MHz the interconnection between the injector and the circuit being tested can become quite critical. It is essential that ripple from the injector power supply does not dramatically degrade the dynamic range or the signal to noise ratio of the measurement. The resulting plots are often much cleaner when using a solid state injector than with a transformer injector.
The selection of a valid injection point in the circuit is more critical when using a solid state injector than with the transformer injector. The solid state injector presents an infinite impedance between the points of injection. In order to provide correct results one side of the measurement must present a much higher impedance than the other side. In a typical power supply control loop, the voltage sense divider is generally a good injection point, since the output impedance of the power supply is very low compared with the impedance of the voltage sense divider.
The solid state injector has a limitation in the operating voltage, with the majority limited to 10V or 12V. This is not the amplitude of the injection signal, but the peak value (positive or negative) of the signal operating voltage.
搜好货厂家苏州迪东电子科技有限公司为您提供PICOTEST 信号注入变压器 测试信号转换器 J2110A 50Ω輸入阻抗的详细产品价格、产品图片等产品介绍信息,您可以直接联系厂家获取PICOTEST 信号注入变压器 测试信号转换器 J2110A 50Ω輸入阻抗的具体资料,联系时请说明是在搜好货网看到的。
品牌 : | PICOTEST |
型号 : | J2110A |
加工定制 : | 否 |
类型 : | 信号注入变压器 |
频率 : | DC~45MHz |
联 系 人
联系电话
采购说明